Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information Users entering EXEC Privilege mode or any other congured privilege level can access conguration commands. To
protect against unauthorized access, use the enable password command to congure a password for the
enable command at a specic privilege level. If no privilege level is specied, the default is privilege level 15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related Commands
• enable password — congures a password for the enable command and to access a privilege level.
role
Changes command permissions for roles.
Syntax
role mode { { { addrole | deleterole } role-name } | reset } command
To delete access to a command, use the no role mode role-name
Parameters
mode
Enter one of the following keywords as the mode for which you are controlling access:
congure for CONFIGURATION mode
exec for EXEC mode
interface for INTERFACE modes
line for LINE mode
route-map for Route-map mode
router for Router mode
addrole Enter the keyword addrole to add permission to the command. You cannot add or
delete rights for the sysadmin role.
deleterole
Enter the keyword deleterole to remove access to the command. You cannot add or
delete rights for the sysadmin role.
Security 1699