Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related Commands
• line — applies an authentication method list to the designated terminal lines.
• ip access-list standard — names (or selects) a standard access list to lter based on the IP address.
• ip access-list extended — names (or selects) an extended access list based on the IP addresses or protocols.
enable password
Change the password for the enable command.
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type] password [level
level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the level of access. The range
is from 1 to 15.
encryption-type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text string must be a password
that was already encrypted by a Dell EMC Networking router.
Use this parameter only with a password that you copied from the show running-
config le of another Dell EMC Networking router.
password Enter a text string, up to 96 characters long, as the clear text password.
Defaults No password is congured. level = 15.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.13(0.0) Changed the maximum length of the password from 32 to 96.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
Security 1605