Users Guide

Version Description
8.3.29.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Related Commands
• ip prex-list — enters PREFIX-LIST mode and congures a prex list.
distribute-list out
Congure a lter for outgoing routing updates.
S4048–ON
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | isis |ospf
| static]
To delete the lter, use the no distribute-list prefix-list-name out command.
Parameters
prex-list-name Enter the name of a congured prex list.
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to lter only directly connected routes.
isis (OPTIONAL) Enter the keyword isis to lter only IS-IS routes.
ospf (OPTIONAL) Enter the keyword ospf to lter all OSPF routes.
static (OPTIONAL) Enter the keyword static to lter manually congured routes.
Defaults Not congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Routing Information Protocol (RIP) 1531