Users Guide

Field Description
Status (Allowed
ports)
Indicates if the input policy map conguration on an interface belonging to a stack-unit/
port-pipe is successful — Allowed (n) — or not successful — Exception. The allowed
number (n) indicates the number of ports in that port-pipe on which the Policy Map can
be applied successfully.
NOTE: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed; therefore, the output contains only
L2ACL CAM partition entries.
Example
DellEMC# test cam-usage service-policy input pmap_l2 stack-unit all
For a L2 Input Policy Map pmap_l2, the output must be as follows,
stack-unit|Portpipe|CAM Partition|Available CAM|Estimated CAM per Port |Status
| | | |per Port |
(Allowed ports)
0 0 L2ACL 500 200
Allowed (2)
0 1 L2ACL 100 200
Exception
1 0 L2ACL 1000 200
Allowed (5)
1 1 L2ACL 0 200
Exception
…
…
…
13 1 L2ACL 400 200 Allowed (2)
DellEMC#
threshold
Specify the minimum and maximum threshold values for the congured WRED proles.
S4048–ON
Syntax
threshold min number max number max-drop-drop
To remove the threshold values, use the no threshold min number max number command.
Parameters
min number Enter the keyword min then the minimum threshold number for the WRED prole. The
range is from 1 to 9360.
max number Enter the keyword max then the maximum threshold number for the WRED prole. The
range is from 1 to 9360 KB.
max-drop-drop
number
Enter the keyword max-drop-drop followed by the maximum number of packets for the
WRED prole. The range is from 0 to 100 KB
Defaults none
Command Modes CONFIGURATION (cong-wred)
Quality of Service (QoS) 1509