Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip dscp and set ip ttl
parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information The monitor command is saved in the running conguration at Monitor Session mode level and can be restored
after a chassis reload.
Example
DellEMC# show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL
------ ------ ----------- --- ---- --------- -------- ---- ---
0 Te 1/12 remote-ip rx Flow 1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow 1.1.1.1 7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1 3.1.1.2 0 255
Related Command
• show monitor session — displays the monitor session.
• show running-cong monitor session — displays the running conguration of a monitor session.
rate-limit
Congure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
Port Monitoring 1431