Users Guide

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Related Commands
• monitor session — enables a monitoring session.
erpm
Congure the source and destination IP address for ERPM trac.
Syntax
erpm source-ip ip-address dest-ip ip-address [gre-protocol value]
To remove the conguration, use the no erpm source-ip IP-address dest-ip IP-address [gre-
protocol value] command.
Parameters
source–ip ip-
address
Enter the keywords source-ip then the source IP address in dotted decimal format.
destination–ip ip-
address
Enter the keywords dest-ip then the destination IP address in dotted decimal format.
gre–protocol value (OPTIONAL) Enter the keywords gre-protocol then the protocol type value for
ERPM type monitor session. The range is from 1 to 65535.
1428 Port Monitoring