Users Guide
NOTE: Applies to specic VRF if input is provided, else applies to Default VRF.
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and 3x/32
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on S6000, S4810, S4820T, Z9000,
Z9500, and S6000–ON.
9.7(0.0) Added support for VRF.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Usage Information
Dell EMC Networking OS supports standard access lists for the SSM range. You cannot use extended ACLs for
conguring the SSM range. If you congure an extended ACL and then used in the ip pim ssm-range
{access list name} conguration, an error is reported.
However, if you congure ip pim ssm-range {access list name} rst and then you congure the ACL
as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range.
Dell EMC Networking OS-recommended best-practices are to congure the standard ACL, and then apply the
ACL to the SSM range. After the SSM range is applied, the changes are applied internally without requiring clearing
of the tree information base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM) modules apply the new rules
automatically.
PIM-Sparse Mode (PIM-SM) 1409