Users Guide

• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the port command
parameter.)
source port Enter the keywords source-port then the port number to be matched in the ACL rule
in the ICAP rule
destination-port Enter the keywords destination-port then the port number to be matched in the
ACL rule in the ICAP rule.
source-port-range Enter the keywords Source-port-range then the range of the start port to end port
to be matched in the ACL rule in the ICAP rule.
destination-port-
range
Enter the keywords destination-port-range then the range of the start port to
end port to be matched in the ACL rule in the ICAP rule.
Defaults none
Command Modes REDIRECT-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for the track-id on the S4810, S4820T, S6000, S6000-ON, and Z9000.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Policy-based Routing (PBR) 1389