Users Guide

mask Enter a network mask in /prex format (/x).
any Enter the keyword any to specify that all trac is subject to the lter.
host ip-address Enter the keyword host then he IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP ags:
• ack = acknowledgement
• fin = nish (no more data from the user)
•
psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the portcommand
parameter.)
Defaults None
Command Modes REDIRECT-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
Policy-based Routing (PBR) 1385