Users Guide
EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# show ipv6 ospf 3 neighbor gi 1/2
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Te 1/2
DellEMC#
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path rst (SPF) calculation.
S4048–ON
Syntax
timers spf delay holdtime msec
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 2147483647. The default is 5
seconds. When congured in milli seconds, 100 is the least value that is allowed to be
congured.
holdtime Enter a number as the hold time. The range is from 0 to 2147483647. The default is 10
seconds. When congured in milli seconds, 200 is the least value that is allowed to be
congured.
Open Shortest Path First (OSPFv2 and OSPFv3) 1379