Users Guide

For SHA-1 authentication, the key must be 40 hex digits (non-encrypted) or 80 hex digits
(encrypted).
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on S4810 and Z9000.
8.4.2.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information
Before you enable IPsec authentication on an OSPFv3 interface, rst enable IPv6 unicast routing globally, congure
an IPv6 address and enable OSPFv3 on the interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the router. Congure
the same authentication policy (same SPI and key) on each OSPFv3 interface in a link.
To remove an IPsec authentication policy from an interface, enter the no ipv6 ospf authentication spi number
command. To remove null authentication on an interface to allow the interface to inherit the authentication policy
congured for the OSPFv3 area, enter the no ipv6 ospf authentication null command.
Related Commands
• area authentication – congure an IPsec authentication policy for an OSPFv3 area.
• show crypto ipsec policy – display the conguration of IPsec authentication policies.
• show crypto ipsec sa ipv6 – display the security associations set up for OSPFv3 interfaces in authentication
policies.
ipv6 ospf bfd all-neighbors
Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session parameters.
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval min_rx min_rx
multiplier value role {active | passive}]]
1356 Open Shortest Path First (OSPFv2 and OSPFv3)