Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information
You can congure an UP and/or DOWN timer for each tracked object to set the time delay before a change in the
state of a tracked object is communicated to clients. The congured time delay starts when the state changes
from UP to DOWN or vice-versa.
If the state of an object changes back to its former UP/DOWN state before the timer expires, the timer is
cancelled and the client is not notied. For example, if the DOWN timer is running when an interface goes down
and comes back up, the DOWN timer is cancelled and the client is not notied of the event.
If the timer expires and an object’s state has changed, a notication is sent to the client. If no delay is congured, a
notication is sent immediately after a change in the state of a tracked object is detected. The time delay in
communicating a state change is specied in seconds.
Related Commands
• track interface ip routing – congure object tracking on the routing status of an IPv4 Layer 3 interface.
• track interface line-protocol – congure object tracking on the line-protocol state of a Layer 2 interface.
• track ip route metric threshold – congure object tracking on the threshold of an IPv4 route metric.
• track ip route reachability – congure object tracking on the reachability of an IPv4 route.
description
Enter a description of a tracked object.
Syntax
description {text}
To remove the description, use the no description {text} command.
Parameters
text Enter a description to identify a tracked object (80 characters maximum).
Defaults None
Command Modes OBJECT TRACKING (conf_track_object-id)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
Object Tracking 1235