Users Guide

Multicast

The multicast commands are supported by Dell EMC Networking OS.

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base,

use the

clear ip pim tib command.

Syntax

clear ip mroute [vrf vrf-name] {group-address [source-address] | *}

Parameters

vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to congure this

setting on that VRF.

NOTE: Applies to specic VRF if input is provided, else applies to Default VRF.

group-address

[source-address]

Enter the multicast group address and source address (if desired), in dotted decimal

format, to clear information on a specic group.

* Enter * to clear all multicast routes.

Command Modes EXEC Privilege

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.11.(3.0) Removed support for keyword snooping.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

1204 Multicast