Users Guide

Use the ip ftp password command when you use the ftp: parameter in the copy command.
Related Commands
ip ftp source-interface
Specify an interface’s IP address as the source IP address for FTP connections.
Syntax
ip ftp source-interface interface
To delete an interface, use the no ip ftp source-interface interface command.
Parameters
interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Control and Monitoring 119