Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# show running-config lldp
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 15
multiplier 3
no disable
DellEMC#
snmp-notication-interval
Used to congure the value for the lldp notication interval, to throttle lldp notication messages.
Syntax
[no] snmp-notification-interval [seconds]
To disable this feature, use the no snmp-notification-interval command.
Parameters
seconds Enter a value from 5 to 3600 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(2.5) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6010–ON and Z9100–ON
Usage Information
SNMP notication for the changes in the lldp remote entry table is throttled by 5 seconds (default), or the
congured time set using this command. If more than one notication message is generated within the congured
time, only the rst one will be sent and the remaining messages are suppressed.
LLDP-MED Commands
The following are the LLDP-MED (Media Endpoint Discovery) commands.
Dell EMC Networking OS LLDP-MED commands are an extension of the set of LLDP TLV advertisement commands.
Link Layer Discovery Protocol (LLDP)
1139