Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
Congure a network entity title (the net command) to specify the area address and the router system ID.
Enable routing on one or more interfaces to establish adjacencies and establish dynamic routing.
You can congure only one IS-IS routing process to perform Level 2 routing. A level-1-2 designation performs
Level 1 and Level 2 routing at the same time.
Related Commands
• ip router isis — congure IS-IS routing processes for IP on interfaces and attaches an area designator to the
routing process.
• net — congure an IS-IS network entity title (NET) for a routing process.
• is-type — assign a type for a given area.
set-overload-bit
To set the overload bit in zeroth fragment of non-pseudonode LSPs on the router, congure the router. This setting prevents other routers
from using it as an intermediate hop in their shortest path rst (SPF) calculations.
Syntax
set-overload-bit
To return to the default values, use the no set-overload-bit command.
Defaults Not set.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Intermediate System to Intermediate System (IS-IS) 1053