Service Manual

ResId Resource Parameter State LastChange
2 IPv6 route metric threshold 2040::/64 Up 00:02:36
3 IPv6 route reachability 2050::/64 Up 00:02:36
Related
Commands
● show running-config track – displays configuration information about tracked objects.
● show track – displays information about tracked objects, including configuration, current state, and
clients which track the object.
● track interface ipv6 routing – configures object tracking on the routing status of an IPv6 Layer 3
interface.
● track ipv6 route metric threshold – configures object tracking on the threshold of an IPv6 route
metric.
● track ipv6 route reachability – configures object tracking on the reachability of an IPv6 route.
track interface ipv6 routing
Configure object tracking on the routing status of an IPv6 Layer 3 interface.
Syntax
track object-id interface interface ipv6 routing
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
interface Enter one of the following values:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a tunnel interface, enter the keyword tunnel.
●
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command
History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage
Information
Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface:
● The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the
interface has a valid IP address.
● The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes down (for a Layer 3
VLAN, all VLAN ports must be down) or the IP address is removed from the routing table.
Related
Commands
● show track ipv6 route – displays information about tracked IPv6 routes, including configuration,
current state, and clients which track the route.
● track interface ip routing – configures object tracking on the routing status of an IPv4 Layer 3
interface.
986 Object Tracking