Service Manual

Designated port id is 128.257, designated path cost 0
Number of transitions to forwarding state 1
BPDU (MRecords): sent 21, received 9
The port is not in the Edge port mode
Usage
Information
The following describes the show spanning-tree msti 5 guard command shown in the following
example.
Field Description
Interface Name MSTP interface.
Instance MSTP instance.
Sts Port state: root-inconsistent (INCON Root), forwarding (FWD), listening (LIS),
blocking (BLK), or shut down (EDS Shut).
Guard Type Type of STP guard configured (Root, Loop, or BPDU guard).
Example (Guard)
Dell#show spanning-tree msti 5 guard
Interface
Name Instance Sts Guard type
------------------------------------
Te 1/1 5 INCON(Root) Rootguard
Te 1/2 5 FWD Loopguard
Te 1/3 5 EDS(Shut) Bpduguard
spanning-tree
Enable the multiple spanning tree protocol on the interface.
Syntax
spanning-tree
To disable the multiple spanning tree protocol on the interface, use the no spanning-tree command.
Parameters
spanning-tree Enter the keywords spanning-tree to enable the MSTP on the interface.
Defaults Enable.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
Multiple Spanning Tree Protocol (MSTP) 949