Service Manual

If the total number of SA messages is already larger than the limit when this command is applied, those
SA messages that are already in Dell Networking OS continue to be accepted. To enforce the limit in such
situation, use the clear ip msdp sa-cache command.
Related
Commands
ip msdp peer — configures the MSDP peer.
clear ip msdp peer — clears the MSDP peer.
show ip msdp — displays the MSDP information.
ip msdp shutdown
Administratively shut down a configured MSDP peer.
Syntax
ip msdp shutdown {peer address}
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced
ip multicast-msdp
Enable MSDP.
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
934 Multicast Source Discovery Protocol (MSDP)