Service Manual

connect-source
interface
Enter the keywords connect-source then one of the interfaces and slot/port or
number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
●
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
description name (OPTIONAL) Enter the keyword description then a description name (maximum 80
characters) to designate a description for the MSDP peer.
sa-limit number (OPTIONAL) Enter the maximum number of SA entries in SA-cache. The range is
from 1 to 100000. .
Defaults As described in the Parameters section.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.5.1.0 Added option for SA upper limit and the description option.
6.2.1.1 Introduced
Usage
Information
The connect-source option is used to supply a source IP address for the TCP connection. When an
interface is specified using the connect-source option, the primary configured address on the
interface is used.
If the total number of SA messages received from the peer is already larger than the limit when this
command is applied, those SA messages continue to be accepted. To enforce the limit in such situation,
use the clear ip msdp peer command to reset the peer.
Related
Commands
ip msdp sa-limit — configures the MSDP SA Limit.
clear ip msdp peer — clears the MSDP peer.
show ip msdp — displays the MSDP information.
Multicast Source Discovery Protocol (MSDP) 931