Service Manual

mac-address-table static (for Multicast MAC
Address)
For multicast mode of network load balancing (NLB), configure a static multicast MAC address, associate the multicast MAC
address with the VLAN used to switch Layer 2 multicast traffic, and add output ports that will receive multicast streams on the
VLAN. To delete a configured static multicast MAC address from the MAC address table on the router, enter the no mac-
address-table static multicast-mac-address command.
Syntax
mac-address-table static multicast-mac-address multicast vlan vlan-id
range-output {single-interface | interface-list | interface-range}
To remove a MAC address, use the no mac-address-table static multicast-mac-address
output interface vlan vlan-id command.
Parameters
multicast-mac-
address
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
multicast Enter a vlan port to where L2 multicast MAC traffic is forwarded.
NOTE: Use this option if you want multicast functionality in an L2 VLAN
without IGMP protocols.
output interface For a multicast MAC address, enter the keyword output then one of the following
interfaces for which traffic is forwarded:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
output-range
interface
For a multicast MAC address, enter the keyword output-range then one of the
following interfaces to indicate a range of ports for which traffic is forwarded:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.3(0.0) Added support for multicast MAC address on the MXL platform.
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range
Te 1/2,Te 1/3}
922 Microsoft Network Load Balancing