Service Manual

Example
Dell(conf-if-vl-100)#show config
!
interface Vlan 100
no ip address
no shutdown
Dell(conf-if-vl-100)#
show vlan
Display the current VLAN configurations on the switch.
Syntax
show vlan [brief | id vlan-id | name vlan-name]
Parameters
brief (OPTIONAL) Enter the keyword brief to display the following information:
● VLAN ID
● VLAN name (left blank if none is configured)
● Spanning Tree Group ID
● MAC address aging time
● IP address
id vlan-id (OPTIONAL) Enter the keyword id then a number from 1 to 4094. Only
information on the VLAN specified is displayed.
name vlan-name (OPTIONAL) Enter the keyword name then the name configured for the VLAN.
Only information on the VLAN named is displayed.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Updated to support OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Augmented to display PVLAN data for the C-Series and S-Series and revised the
output to include the Description field to display a user-entered VLAN description.
7.6.1.0 Introduced on the S-Series and revised the output to display Native VLAN.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
The following describes the show vlan command shown in the following example.
Layer 2 885