Service Manual

Version Description
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
After entering the banner login command, type one or more spaces and a delineator character. Enter the
banner text then the second delineator character. When the user is connected to the router, if a message
of the day banner is configured, it displays first. If no message of the day banner is configured, the login
banner and prompt appear. After the user has logged in, the banner EXEC (if configured) displays.
Related
Commands
banner exec — enables the display of a text string when you enter EXEC mode.
banner login — sets a banner to display after successful login to the system.
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos]
number ecfmacl number {fcoeacl number} {iscsioptacl {0|2}} {openflow {4|8}}
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L3 ACL (ipv4acl): 4
● L2 ACL(l2acl): 6
● IPv6 L3 ACL (ipv6acl): 0
● L3 QoS (ipv4qos): 2
● L2 QoS (l2qos): 1
● OpenFlow: 0 (disabled)
● FCoE (fcoeacl): 0 (disabled)
● iSCSI Optimization (iscsioptacl): 0 (disabled)
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be allotted. The
total space allocated must equal 13. The ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
● 4: Creates 242 entries for use by the OpenFlow controller (256 total entries
minus the 14 entries reserved for internal functionality)
● 8: Creates 498 entries for use by the OpenFlow controller (512 total entries
minus the 14 entries reserved for internal functionality)
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
86 Control and Monitoring