Service Manual

address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
Display the IS-IS link state database.
Syntax
show isis [vrf vrf-name] database [level-1 | level-2] [local] [detail |
summary] [system-id] [lspid]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to display IS-IS
link state database corresponding to that VRF.
NOTE: If you do not specify this option, the IS-IS link state database
corresponding to the default VRF are displayed.
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
detail (OPTIONAL) Displays the detailed link-state database information of each LSP
when specified. If not specified, a summary displays.
summary (OPTIONAL) Displays the summary of link-state database information when
specified.
lspid (OPTIONAL) Display only the specified LSP.
system-id (OPTIONAL) Displays the link-state database for system-id.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
Usage
Information
The following describes the show isis database command shown in the following example.
848 Intermediate System to Intermediate System (IS-IS)