Service Manual

banner exec
Configure a message that is displayed when your enter EXEC mode.
Syntax
banner exec c line c
To delete a banner, use the no banner exec command.
Parameters
c Enter the keywords banner exec, then enter a character delineator, represented
here by the letter c. Press ENTER.
line Enter a text string for your banner message ending the message with your
delineator. In the following example, the delineator is a percent character (%); the
banner message is “testing, testing”.
Defaults No banner is displayed.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original Command
Usage
Information
After entering the banner login command, type one or more spaces and a delineator character. Enter the
banner text then the second delineator character. When the user is connected to the router, if a message
of the day banner is configured, it displays first. If no message of the day banner is configured, the login
banner and prompt appear. After the user has logged in, the banner EXEC (if configured) displays.
Example
Dell(conf)#banner exec ?
LINE c banner-text c, where 'c' is a delimiting character
Dell(conf)#banner exec %
Enter TEXT message. End with the character '%'.
This is the banner%
Dell(conf)#end
Dell#exit
4d21h5m: %RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated for user
on line
console
This is the banner
Dell con0 now available
Press RETURN to get started.
Control and Monitoring 83