Service Manual

Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a Null interface, enter the keyword null then the Null interface number.
●
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For stacking, enter the keywords stack-unit then the stack-unit ID.
● For a tunnel interface, enter the keyword tunnel then the tunnel ID.
brief (OPTIONAL) View a summary of IPv6 interfaces.
configured (OPTIONAL) View information on all IPv6 configured interfaces.
managementethe
rnet slot/ port
(OPTIONAL) View information on an IPv6 Management port. Enter the slot number
(0-1) and port number zero (0).
loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitethern
et
(OPTIONAL) View information for an IPv6 tengigabitethernet interface.
fortyGigE (OPTIONAL) View information for an IPv6 fortygigabitethernet interface.
stack-unit id (OPTIONAL) View information for stacking.
tunnel tunnel-id (OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1)
Added support for IPv6 recursive DNS addresses on the Z9500.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for tunnel interface.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
IPv6 Basics 789