Service Manual

that has a mask greater than 64, if the first 64 bits in the destination routes of the ECMP objects are
the same, only one route is installed in CAM even though multiple ECMP path entries exist.
NOTE: The self address is displayed in the neighbor portion for the show ipv6 cam stack-unit
unit-number port-set command.
show ipv6 control-plane icmp
Displays the status of the icmp control-plane setting for the error eate limit setting.
Syntax
show ipv6 control-plane icmp
Default 100
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related
Commands
ipv6 flowlabel-zero — Configure IPv6 address auto-configuration for the management interface.
show ipv6 fib stack-unit
View all FIB entries.
Syntax
show ipv6 fib [vrf vrf-name] stack-unit unit-number [summary | ipv6-
address]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to display
neighbors corresponding to that VRF.
slot-number Enter the number of the stack unit.
summary (OPTIONAL) Enter the keyword summary to view a summary of entries in IPv6
cam.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have
more specific prefixes. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Command Modes
● EXEC
● EXEC Privilege
IPv6 Basics 787