Service Manual

where hostip is either an IPv4 dotted decimal address or an IPv6 URI [x:x:x:x::x]

format address.

Defaults none

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.0(0.0) Added support for IPv6 for the file-url parameter.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Added support for TFTP and SCP.

7.6.1.0 Introduced on the S-Series.

Usage

Information

RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must be enclosed in

square brackets, [X:X:X:X::X]. For maximum flexibility this command accepts IPv6 host addresses with or

without the square brackets.

Reload Dell Networking OS after executing this command. To copy Dell Networking OS from the

management unit to one or more stack members, use the upgrade system stack-unit (S-

Series stack member) command.

Example

Dell# upgrade system ?

ftp:Copy from remote file system(ftp://userid:password@hostip/filepath)

scp:Copy from remote file system(scp://userid:password@hostip/filepath)

tftp:Copy from remote file system(tftp://hostip/filepath)

Dell# upgrade system ftp://username:password@10.11.1.1/FTOS-

SB-7.7.1.0.bin

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Erasing Sseries ImageUpgrade Table of Contents, please wait

..................................................

....................................!

12946259 bytes successfully copied

Dell# reload

upgrade system

Upgrade the Dell Networking OS image. To upgrade the bootflash or bootselector image, use the upgrade boot command.

Syntax

upgrade system {flash: | ftp: | nfsmount: | scp: | stack-unit {stack-unit-

id | all} | tftp: | usbflash:} file-url {A: |B:}

Parameters

system Enter the keyword system to upgrade the operating system (OS) image.

78 File Management