Service Manual

IPv6 Basics
IPv6 basic commands are supported on the Dell Networking OS.
NOTE: For information about the Dell Networking operating software version and platform that supports IPv6 in each
software feature, refer to the IPv6 Addressing chapter of the Dell Networking OS Configuration Guide.
Topics:
• clear ipv6 fib
• clear ipv6 route
• clear ipv6 mld_host
• maximum dynamic-routes-ipv6
• ipv6 address autoconfig
• ipv6 address
• ipv6 address eui64
• ipv6 control-plane icmp error-rate-limit
• ipv6 flowlabel-zero
• ipv6 host
• ipv6 name-server
• ipv6 nd dad attempts
• ipv6 nd dns-server
• ipv6 nd prefix
• ipv6 route
• ipv6 unicast-routing
• show ipv6 cam stack-unit
• show ipv6 control-plane icmp
• show ipv6 fib stack-unit
• show ipv6 flowlabel-zero
• show ipv6 interface
• show ipv6 mld_host
• show ipv6 route
• trust ipv6-diffserv
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
Syntax
clear ipv6 fib [vrf vrf-name] linecard slot | stack-unit unit-number
Parameters
vrf vrf–name (Optional) Enter the keyword vrf followed by the name of the VRF to clear the
neighbor corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are cleared.
slot Enter the slot number to clear the FIB for a linecard.
unit-number Enter the stack member number. The range is from 1to 6
Command Modes EXEC Privilege
28
IPv6 Basics 773