Service Manual

● database — view a list of ARP entries learned using DAI
● statistics — view DAI statistics
macaddress mac-
address mask
(OPTIONAL) Enter the keyword macaddress then a MAC address in
nn:nn:nn:nn:nn:nn format. Enter the optional MAC address mask in nn:nn:nn:nn:nn
format also.
static (OPTIONAL) Enter the keyword static to view entries entered manually.
retries (OPTIONAL) Enter the keyword retries to show the number of ARP retries
before a 20–second back off.
dynamic (OPTIONAL) Enter the keyword dynamic to view dynamic entries.
summary (OPTIONAL) Enter the keyword summary to view a summary of ARP entries.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was
2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.8.1.0 Augmented to display local ARP entries learned from private VLANs (PVLANs).
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The following example shows two VLANs that are associated with a private VLAN (PVLAN) (refer to
Private VLAN (PVLAN)).
If you have entered the clear arp-cache command to remove a large number of ARP entries and the
command is still being processed in the background, an error message display if you attempt to enter the
show arp command:
Clear arp in-progress. Please try after sometime!
The following describes the show arp command shown in the following example.
Description
Protocol Displays the protocol type.
Address Displays the IP address of the ARP entry.
IPv4 Routing 741