Service Manual

Version Description
pre-6.1.1.0 Introduced on the E-Series.
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
load-balance
By default, for C-Series and S-Series, Dell Networking OS uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port)
to distribute IP traffic over members of a Port Channel as well as equal-cost paths. To designate another method to balance
traffic over Port Channel members, use the load-balance command.
Syntax
load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac |
source-dest-mac | source-mac]} | {tcp-udp | ingress-port [enable]}
To return to the default setting (IP 4-tuple), use the no load-balance {ip-selection [dest-
ip | source-ip]} | {mac [dest-mac | source-dest-mac | source-mac]} | {tcp-
udp | ingress-port [enable]}command.
736 IPv4 Routing