Service Manual

clear ip route
Clear one or all routes in the routing table.
Syntax
clear ip route [vrf vrf-name] {* | ip-address mask}
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to clear the
routes corresponding to that VRF.
* Enter an asterisk (*) to clear all learned IP routes.
ip-address mask Enter a specific IP address and mask in dotted decimal format to clear that IP
address from the routing table.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
Use the vrf vrf-name attribute of this command to clear routes corresponding to either a specific
VRF or the default VRF.
You cannot use this attribute to clear routes corresponding to a management VRF.
Related
Commands
ip route — assigns an IP route to the switch.
show ip route — views the routing table.
show ip route summary — views a summary of the routing table.
clear tcp statistics
Clear TCP counters.
Syntax
clear tcp statistics [all | cp]
IPv4 Routing 713