Service Manual

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
management route — configures a static route that points to the Management interface or a forwarding
router.
stack-unit portmode
Split a single 40G port into four-10G portsConvert a single 100G port into one 40G port, or four 10G, 25G, or two 50G, or one
40G ports.
S4048–ON
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset. For the
S6000–ON, the range is from 1 to 6.
number Enter the port number of the 40G port to be split.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S4048-ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on
the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage
Information
Splitting a 40G port into 4x10G port is supported on standalone and stacked units. stack-unit
stack-unit port number portmode quad dynamically fan-out 40G ports to 10G ports and vice-
versa without reload in switch.
Interfaces 675