Service Manual
Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This command is found on the 10/100/1000 Base-T Ethernet interfaces.
When you enable auto, the system performs an automatic discovery to determine the optics installed
and configure the appropriate speed.
When you configure a speed for the 10/100/1000 interface, confirm the negotiation auto command
setting. Both sides of the link must have auto-negotiation either enabled or disabled. For speed settings
of 1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed with
the speed command. When you set the speed to 10 or 100 Mbps, you can also use the duplex
command.
Related
Commands
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with the speed set to
10/100.
negotiation auto — enables or disables auto-negotiation on an interface.
speed (Management interface)
Set the speed for the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
1000 Enter the keyword 1000 to set the interface to auto-negotiate its speed.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
674 Interfaces