Service Manual

command on a port channel disables all traffic on the port channel and the individual interfaces within the
port channel. To enable a port channel, enter no shutdown on the port channel interface and at least
one interface within that port channel.
The shutdown and description commands are the only commands that you can configure on an
interface that is a member of a port channel.
Related
Commands
interface port-channel — creates a port channel interface.
interface vlan — creates a VLAN.
show ip interface — displays the interface routing status. Add the keyword brief to display a table of
interfaces and their status.
speed (for 10/100/1000 interfaces)
Set the speed for 10/100/1000 Base-T Ethernet interfaces. Set both sides of a link to the same speed (10/100/1000) or to auto
or the link may not come up.
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-EH-GE-50P or the
LC-EJ-GE-50P card. If the command is entered for these interfaces, an error
message appears.
100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
NOTE: When this setting is enabled, only 100Base-FX optics are supported on
the LC-EH-GE-50P or the LC-EJ-GE-50P card.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s. Auto-
negotiation is enabled. For more information, refer to negotiation auto.
NOTE: When this setting is enabled, only 100oBase-FX optics are supported
on the LC-EH-GE-50P or the LC-EJ-GE-50P card.
auto Enter the keyword auto to set the interface to auto-negotiate its speed. Auto-
negotiation is enabled. For more information, refer to negotiation auto.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
Interfaces 673