Service Manual

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell(conf)#interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-gi-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type slot/port//[subport]
Parameters
interface Enter one of the following keywords and slot/port[/subport] or number
information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For stack-units, enter the keywords stack-unit then the slot/port
information.
● For a Null interface, enter the keyword null then the Null interface number.
● For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is different from how you specify in non-
ON platforms.
Interfaces 651