Service Manual

rate-interval
Configure the traffic sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data. The range is from 5
to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced
Usage
Information
The output of the show interfaces command displays the configured rate interval, along with the
collected traffic data.
Related
Commands
show interfaces — displays information on physical and virtual interfaces.
show config
Display the interface configuration.
Syntax
show config
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Interfaces 649