Service Manual

!
interface TenGigabitEthernet 1/5
no ip address
shutdown
Related
Commands
show running-config – displays the current configuration.
description
Assign a descriptive text string to the interface.
Syntax
description desc_text
To delete a description, use the no description command.
Parameters
desc_text Enter a text string up to 240 characters long.
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Modified for E-Series: Revised from 78 to 240 characters.
Usage
Information
Important Points to Remember:
● To use special characters as a part of the description string, you must enclose the whole string in
double quotes.
● Spaces between characters are not preserved after entering this command unless you enclose the
entire description in quotation marks (“desc_text”).
● Entering a text string after the description command overwrites any previous text string that you
previously configured as the description.
● The shutdown and description commands are the only commands that you can configure on an
interface that is a member of a port-channel.
● Use the show interfaces description command to display descriptions configured for each
interface.
Interfaces 627