Service Manual
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/
[subport] - slot/port/[subport]. For example, if you want to
clear the port configurations corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type
1/1/1 - 1/1/4.
vrrp [[ipv6]
vrid
] (OPTIONAL) Enter the keyword vrrp to clear the counters of all VRRP groups. To
clear the counters of VRRP groups on all IPv6 interfaces, enter ipv6. To clear the
counters of a specified group, enter a VRID number from 1 to 255.
learning-limit (OPTIONAL) Enter the keywords learning-limit to clear unknown source
address (SA) drop counters when MAC learning limit is configured on the interface.
vlan
vlan-id
Enter the keyword vlan followed by the interface VLAN number. The range is
from 1 to 4094.
Defaults Without an interface specified, the command clears all interface counters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Added support to clear the interface configurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.1.0 Added support (E-Series only) for VRRP groups in a VRF instance.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4093 VLANs on the E-Series ExaScale. Prior to the release,
2094 was supported.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Updated the definition of the learning-limit option for clarity.
Example
Dell#clear counters
Clear counters on all interfaces [confirm]
Related
Commands
mac learning-limit — allows aging of MACs even though a learning-limit is configured or disallow station
move on learned MACs.
show interfaces — displays information on the interfaces.
Interfaces 623