Service Manual

redundancy primary
Set an RPM as the primary RPM.
Syntax
redundancy primary [rpm0 | rpm1]
To delete a configuration, use the no redundancy primary command.
Parameters
rpm0 Enter the keyword rpm0 to set the RPM in slot R0 as the primary RPM.
rpm1 Enter the keyword rpm1 to set the RPM in slot R1 as the primary RPM.
Default The RPM in slot R0 is the Primary RPM.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
redundancy protocol
Enable hitless protocols.
Syntax
redundancy protocol {lacp | xstp}
To disable a hitless protocol, use the no redundancy protocol {lacp | xstp} command.
Parameters
lacp Enter the keyword lacp to make LACP hitless.
xstp Enter the keyword xstp to invoke hitless STP (all STP modes — MSTP, PVST+,
RSTP, and STP).
Default Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
592 High Availability (HA)