Service Manual

File Management

This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as other file

management commands.

Topics:

• boot system

• cd

• HTTP Copy via CLI

• copy

• delete

• dir

• format (S-Series)

• fsck flash

• mkdir

• mount nfs

• rmdir

• HTTP Copy via CLI

• rename

• restore factory-defaults

• show boot system

• show bootvar

• show file-systems

• show os-version

• show running-config

• show startup-config

• show version

• upgrade

• upgrade system

boot system

Specify the location where the Dell Networking OS image used to boot the system is stored.

Syntax

boot system {gateway ip address | stack-unit [{stack-unit-number | all]

[default | primary {system: {A: | B: | bmp-boot} | tftp: | secondary]}

To return to the default boot sequence, use the no boot system command.

Parameters

gateway Enter the IP address of the default next-hop gateway for the management subnet.

ip-address

Enter an IP address in dotted decimal format.

stack-unit Enter the stack-unit number for the master switch.

all Enter the keyword all for all the stack units.

stack-unit-

number

Enter the stack-unit number. The range is from 1 to 6.

default Enter the keyword default to use the default Dell Networking OS image.

primary Enter the keyword primary to use the primary Dell Networking OS image.

secondary Enter the keyword secondary to use the secondary Dell Networking OS image.

File Management 55