Service Manual

Prompt Interface Type

Dell(conf-if-

po-0)#

Port-channel interface number

Dell(conf-if-

vl-0)#

VLAN Interface then VLAN number (range 1–4094)

Dell(conf-if-

ma-1/1)#

Management Ethernet interface then slot/port information

Dell(conf-if-

tu-0)#

Tunnel interface then tunnel ID.

Dell(conf-if-

range)#

Designated interface range (used for bulk configuration).

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-

list standard or ip access-list extended command.

To enter IP ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the ip access-list standard or ip access-list extended command. Include a name for the ACL. The

prompt changes to include (conf-std-nacl) or (conf-ext-nacl).

You can return to CONFIGURATION mode by using the exit command.

ISIS ADDRESS-FAMILY Mode

To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to Intermediate System to

Intermediate System (IS-IS).

To enter ISIS ADDRESS-FAMILY mode:

1. Verify that you are logged in to ROUTER ISIS mode.

2. Enter the command address-family ipv6 unicast. The prompt changes to include (conf-router_isis-af_ipv6).

LLDP Mode

To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, refer to Link Layer

Discovery Protocol (LLDP).

To enter LLDP mode:

1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface, verify

that you are logged in to INTERFACE mode.

2. Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-interface-lldp).

LLDP MANAGEMENT INTERFACE Mode

To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT

INTERFACE mode.

To enter LLDP MANAGEMENT INTERFACE mode:

1. Verify that you are logged in to LLDP mode.

2. Enter the management-interface command. The prompt changes to include (conf-lldp-mgmtIf).

CLI Basics