Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Usage
Information
This command enables a hardware watchdog mechanism that automatically reboots an Dell Networking
OS switch/ router with a single unresponsive unit. This behavior is a last-resort mechanism intended to
prevent a manual power cycle.
show hardware layer2
Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer2 {eg-acl | in-acl} stack-unit id port-set 0–0
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to select between
ingress or egress ACL data.
stack- unit id Enter the keyword stack-unit to select a stack ID. The range is from 1 to 6.
port-set 0–0 Enter the keywords port-set with a port-pipe number. . The range is from 0 to
0.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The unit numbers given are internal port numbers.
show hardware layer3
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {acl | qos} stack-unit number port-set 0–0
Parameters
acl | qos Enter either the keyword acl or the keyword qos to select between ACL or QoS
data.
Debugging and Diagnostics 489