Service Manual

Usage
Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This reboot is an automatic process. A
warning message appears when the offline stack-unit command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot after
completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
online stack-unit
Place a stack unit in the online state.
Syntax
online stack-unit number
Parameters
number Enter the stack-unit number. The range is from 1 to 6.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage
Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This reboot is an automatic process. A
warning message appears when the offline stack-unit command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot after
completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit id {counters | unit 0–0 counters | cpu data-plane
statistics | cpu i2c statistics | cpu party-bus statistics | cpu sata-
interface statistics | stack-port 0–127}
486 Debugging and Diagnostics