Service Manual

2 - -
3 - -
4 - -
5 - -
6 - -
7 - -
8 - -
DCBX Commands
The following DCBX commands are supported on the Dell Networking OS.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
Syntax
advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-tlv iscsi
command.
Defaults Enabled
Command Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure iSCSI TLVs to send either globally or on a specified interface. The interface
configuration takes priority over global configuration.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-tlv {fcoe |
iscsi} command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
● fcoe: enables the advertisement of FCoE in application priority TLVs.
● iscsi: enables the advertisement of iSCSI in application priority TLVs.
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command Modes PROTOCOL LLDP
Data Center Bridging (DCB) 461