Service Manual

ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command Modes CONFIGURATION
Command
History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
All the default catch-all entries in the longest prefix match (LPM) table collect and transmit all unresolved
IPv6 packets to the CPU, even if they are destined for unknown destinations.
show cpu-queue rate cp
Display the rates for each CPU queue.
Syntax
show cpu-queue rate cp
Defaults Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies the service-policy based on the type of protocol defined in the ACL rules.
Create ACL and QoS policies prior to enabling this command.
Example
Dell#show cpu-queue rate cp
Service-Queue Rate (PPS) Burst ()
-------------- ----------- -----------
Q0 1300 512
438 Control Plane Policing (CoPP)