Service Manual

User "Irene" on line vty3 ( 123.12.1.321 )
Dell#conf
When another user enters CONFIGURATION mode, Dell Networking OS sends a message similar to the following:
% Warning: User "admin" on line vty2 "172.16.1.210" is in configuration
In this case, the user is “admin” on vty2.
Obtaining Help
As soon as you are in a command mode there are several ways to access help.
To obtain a list of
keywords at any
command mode:
Type a ? at the prompt or after a keyword. There must always be a space before the ?.
To obtain a list of
keywords with a
brief functional
description:
Type help at the prompt.
To obtain a list of
available options:
Type a keyword and then type a space and a ?.
To obtain a list of
partial keywords
using a partial
keyword:
Type a partial keyword and then type a ?.
Example
The following is an example of typing ip ? at the prompt:
Dell(conf)#ip ?
access-list Named access-list
as-path BGP autonomous system path filter
community-list Add a community list entry
domain-list Domain name to complete unqualified host name
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
fib FIB configuration commands
ftp FTP configuration commands
host Add an entry to the ip hostname table
max-frag-count Max. fragmented packets allowed in IP re-assembly
multicast-routing Enable IP multicast forwarding
name-server Specify address of name server to use
pim Protocol Independent Multicast
prefix-list Build a prefix list
radius Interface configuration for RADIUS
redirect-list Named redirect-list
route Establish static routes
scp SCP configuration commands
source-route Process packets with source routing header options
ssh SSH configuration commands
tacacs Interface configuration for TACACS+
telnet Specify telnet options
tftp TFTP configuration commands
trace-group Named trace-list
trace-list Named trace-list
Dell(conf)#ip
When entering commands, you can take advantage of the following timesaving features:
● The commands are not case-sensitive.
● You can enter partial (truncated) command keywords. For example, you can enter int teng 1/1 for the interface
tengigabitethernet 1/1 command.
● To complete keywords in commands, use the TAB key.
● To display the last enabled command, use the up Arrow key.
CLI Basics
43