Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Example
Dell#show ip extcommunity-list test
ip extcommunity-list test
deny RT:1234:12
permit regexp 123
deny regexp 234
deny regexp 123
Dell#
IPv6 BGP Commands
IPv6 border gateway protocol (IPv6 BGP) is supported on the platform.
BGP is an external gateway protocol that transmits interdomain routing information within and between Autonomous Systems
(AS). Basically, two routers (called neighbors or peers) exchange information including full routing tables and periodically send
messages to update those routing tables.
clear ip bgp ipv6 unicast soft
Clear and reapply policies for IPv6 unicast routes without resetting the TCP connection; that is, perform BGP soft
reconfiguration.
Syntax
clear ip bgp {* | as-number | ipv4-neighbor-addr | ipv6-neighbor-addr |
peer-group name} ipv6 unicast soft [in | out]
Parameters
* Clear and reapply policies for all BGP sessions.
as-number Clear and reapply policies for all neighbors belonging to the AS. The range is from 0
to 65535 (2 Byte), from 1 to 4294967295 (4 Byte), or from 0.1 to 0.65535.65535
(Dotted format).
ipv4-neighbor-
addr | ipv6-
neighbor-addr
Clear and reapply policies for a neighbor.
peer-group name Clear and reapply policies for all BGP routers in the specified peer group.
ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Border Gateway Protocol 421