Service Manual
NOTE: You can use this attribute to view information on BGP peers in a peer
group that correspond to either a default or a non-default VRF.
ipv4
multicast
(OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view information related only to ipv4 multicast routes.
ipv4
unicast
(OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
detail (OPTIONAL) Enter the keyword detail to view detailed status information of the
peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status information of the peers
in that peer group. The output is the same as that found in the show ip bgp
summary command.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp peer-group command shown in the following example.
Line beginning
with:
Description
Peer-group Displays the peer group’s name.
Administratively
shut
Displays the peer group’s status if the peer group is not enabled. If you enable the
peer group, this line is not displayed.
BGP version Displays the BGP version supported.
Minimum time Displays the time interval between BGP advertisements.
For address
family
Displays IPv4 Unicast as the address family.
BGP neighbor Displays the name of the BGP neighbor.
Number of peers Displays the number of peers currently configured for this peer group.
408 Border Gateway Protocol