Service Manual

show config
Display the current route map configuration.
Syntax
show config
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
Dell(conf-nprefixl)#show config
!
ip prefix-list PL_OSPF_to_RIP
seq 5 permit 1.1.1.0/24
seq 10 deny 2.1.0.0/16 ge 23
seq 25 permit 192.0.0.0 bitmask 192.0.0.0
show route-map
Display the current route map configurations.
Syntax
show route-map [map-name]
Parameters
map-name (OPTIONAL) Enter the name of a configured route map, up to 140 characters.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
Access Control Lists (ACL) 255